Energy Test; Equipment Needed; Set Up - ZOLL AED 3 Service Manual

Energy Test

Equipment Needed

Power Supply, Battery Test Fixture, ZOLL AED 3 Defib Test Cable Kit, Fluke
Impulse 7000 Defib Analyzer (or equivalent).
NOTE The test values in the following procedure are based of the default adult

Set Up

This test continues from the previous test. The ZOLL AED 3 Defib Test Cable Kit
is connected to the Defib Analyzer, and the waveform is set to VFIB.
Action
1. Disconnect the ZOLL AED 3
Defib Test Cable Kit from the
AED, then press the On/Off
button to turn on the AED.
2. Connect the ZOLL AED 3 Defib
Test Cable Kit to the AED.
3. (First shock energy test. First
adult shock energy is 120
joules.)
4. Press the flashing shock button.
5.
6.
7. Hold the CPR sensor (attached
to the ZOLL AED 3 Defib Test
Cable Kit) in the palm of your
hand. Move your hand in front
of you in an up and down
motion of approximately 2
inches at a rate of 100bpm.
(Conduct test for about 20
seconds.)
9650-000761-01 Rev. A
energy settings (120, 150, and 200 joules) into a 50 ohm load. If the
Analyzer you are using has a different impedance value, refer to the
table "Delivered Energy at Each Defibrillator Setting into a Range of
Loads" on page 13.
Expected Result(s)
Verify that the AED issues the
prompts UNIT OK and PLUG IN
PADS CABLE.
Verify that the AED issues the voice
prompt ADULT PATIENT SELECTED,
followed by IF PATIENT IS A CHILD,
PRESS CHILD BUTTON.
Verify that the AED issues the voice
prompts DON'T TOUCH PATIENT,
ANALYZING, followed by SHOCK
ADVISED, DON'T TOUCH PATIENT,
and PRESS FLASHING SHOCK
BUTTON.
Verify that the AED issues the
prompt SHOCK DELIVERED.
Verify that the energy delivered into
the analyzer is 100 joules to 135
joules.
Verify that the AED issues the
prompt START CPR.
Verify that the AED displays the CPR
depth compression indicator.
ZOLL AED 3 Service Manual
Pass/Fail
o o
o o
o o
o o
o o
o o
o o
11