Vga Cable Replacement; Remove The Vga Cable (2.5-Inch Drive Model) - Lenovo ThinkSystem SR250 V2 Maintenance Manual

Figure 121. Top cover installation
After you finish
Complete the parts replacement. See

VGA cable replacement

Use the following information to remove and install the VGA cable.

Remove the VGA cable (2.5-inch drive model)

Use this information to remove the VGA cable for the 2.5-inch drive model.
About this task
Attention:
• Read the following section(s) to ensure that you work safely.
– "Safety" on page iii
– "Installation Guidelines" on page 51
• Turn off the server. Disconnect the power cords and all external cables. See
page 11.
• If the server is installed in a rack, remove the server from the rack.
Watch the procedure
A video of this procedure is available at YouTube:
BPZOAqQMD37KjuxaVHVBkH
Step 1. Make preparations for this task.
a. Remove the top cover. See
b. Remove the front operator panel (2.5-inch drive model). See
(2.5-inch drive model)" on page
Step 2. Remove the VGA cable.
"Complete the parts replacement" on page
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"Remove the top cover" on page
81.
140.
"Power off the server" on
132.
"Remove the front operator panel
.
Chapter 4 Hardware replacement procedures
135