Table of Contents
Advertisement
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read the following section(s) to ensure that you work safely.
–
"Safety" on page iii
–
"Installation Guidelines" on page 51
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• If the server is installed in a rack, remove the server from the rack.
• To avoid possible danger, read and follow the following safety information.
Watch the procedure
A video of this procedure is available at YouTube:
BPZOAqQMD37KjuxaVHVBkH
Procedure
Step 1.
Make preparations for this task.
a.
Remove the top cover. See
b.
Disconnect the flash power module cable from the RAID adapter. See
cable routing" on page
Step 2.
Remove the flash power module.
Figure 65. Flash power module removal
a.
Use your finger to lift the flash power module slightly.
b.
Slide the flash power module out of the server.
After you finish
11.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"Remove the top cover" on page
40.
132.
"Flash power module
.
Chapter 4
Hardware replacement procedures
79
Advertisement
Table of Contents
