Table of Contents
Advertisement
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• Do not touch the processor socket or processor contacts. Processor-socket contacts are very fragile and
easily damaged. Contaminants on the processor contacts, such as oil from your skin, can cause
connection failures.
Procedure
Step 1.
Align the four screws on the heat sink with the corresponding screw holes on the system board.
Step 2.
Tighten screw 1 and 2:
a.
Partially tighten screw 1.
b.
Fully tighten screw 2.
c.
Fully tighten screw 1.
Figure 76. Heat sink installation
Step 3.
Tighten screw 3 and 4:
a.
Partially tighten screw 3.
b.
Fully tighten screw 4.
c.
Fully tighten screw 3.
After you finish
1. Install the top cover. See
ThinkSystem SR250 V2 Maintenance Manual
88
"Install the top cover" on page
134.
Advertisement
Table of Contents
