Table of Contents
Advertisement
b.
Disconnect the front operator panel cables from the system board. See
routing" on page
Step 2.
Remove two screws that secure the front operator panel.
Figure 67. Front operator panel screws removal
Step 3.
Slide the front operator panel out of the server.
Figure 68. Front operator panel removal
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the front operator panel (2.5-inch drive model)
Use this information to install the front operator panel (2.5-inch drive model).
About this task
Attention: Read the following section(s) to ensure that you work safely.
•
"Safety" on page iii
•
"Installation Guidelines" on page 51
Watch the procedure
ThinkSystem SR250 V2 Maintenance Manual
82
35.
"Front panel cable
Advertisement
Table of Contents
