Using The 9854 Printer With Dispenser - Avery Dennison Monarch 9844 Operator's Handbook Manual

05/08 Rev. AB
•
•
•
•
•
Disable
Enable
OPERATOR'S HANDBOOK
9844/9854
Possible causes:
– Material is not loaded, or the material's end was not fixed to the takeup
reel. Attach the end to the takeup reel and press Online.
– The material is not stretched tightly. Press Online.
The printer is now ready for the next print job. You may need to adjust the
basic initialization settings because of:
Very small labels
Very rough backing paper
Backing paper much heavier than label
Labels stuck to backing paper
Backing paper perforated along label contour

Using the 9854 Printer with Dispenser

Set SYSTEM PARAMETER > Periph. Device to None
Set SYSTEM PARAMETER > Periph. Device to Dispenser
The printer restarts. The main menu now contains the additional menu
DISPENSER PARA , which holds the parameters required for dispenser
mode:
Parameter Possible Settings
Dispenser Mode Real 1:1 mode (default), batch mode, Normal 1:1 mode
Dispensing Set in millimeters (default: 0.0 mm)
Position
Display Mode Job rest quant. (default), Dispense counter
Dispense counter Preset Amount (default: 0)
Application Mode Safe mode (default), Immediate mode
Start Mode Edge (default), Level low active
Start Source Foot switch (default), Light barrier
Tab. 5: Parameters in the menu DISPENSER PARA.
Refer to the "Info-Printouts and Parameters" section of your CD-ROM for
more information on the listed parameters.
Getting Started
1-15