Offline Operation - Avery Dennison Monarch 9844 Operator's Handbook Manual

Thermotransfer label printers

Hide thumbs

Table Of Contents

Table of Contents

05/08 Rev. AB

•

Configuring the

Dispenser

Position

•

Label length

< 40 mm

•

OPERATOR'S HANDBOOK

9844/9854

Application A:

The label is dispensed (peeled) so that a small portion still sticks to the

backing paper above the dispensing edge. After the dispensed label is

removed, the next label is immediately printed and dispensed.

Set DISPENSER PARA > Dispenseposition to –6.0 mm (set to –8.0 mm if the

material is very adhesive).

Set DISPENSER PARA > Start Source to Light barrier.

Application B:

The printing and dispensing of the label is controlled by the optional foot

switch.

Set SYSTEM PARAMETER > External Signal to Stacker full.

Set DISPENSER PARA > Dispenseposition to –6.0 mm (set to –8.0 mm if the

material is very adhesive).

Set DISPENSER PARA > Start Source to Foot switch.

If using very short labels (< 40 mm) set PRINT PARAMETERS > Material length

< 40 mm (1.6 inches). The printer automatically initializes the material, which

improves the impression accuracy of the printout.

Refer to the "Info-Printouts and Parameters" section on your CD-ROM for

more information on parameter DISPENSER PARA > Calibration mode.