Bulb Replacement - Chevrolet Low Cab Forward 6.7L 2022 Owner's Manual

220 Vehicle Care
2. Two screws should be turned in the
same direction at the same time to
adjust aiming.
3. When the headlamp aiming is out of
position, contact your dealer.

Bulb Replacement

Bulbs
1. Check each bulb for blowout.
2. If a bulb has blown out, replace it.
Always place the engine control switch
in the LOCK position and place all the
other switches in the OFF position
before replacing the blown bulbs.
3. If you need assistance replacing any
bulbs, contact your dealer.
Turn Signals
The flasher unit activates both the turn
signal circuits and the hazard circuit. Should
a lamp burn out, the flasher unit will
continue to operate. Check the turn signal
lamps visually before the vehicle is used.
Bulb Wattage
Warning
Using bulbs with a wattage other than
that specified could cause the bulb or the
wiring to become hot. This could result in
the warping of the lens and case, and it
could also lead to the outbreak of fire.
Bulbs are hot immediately after they go
out. When replacing the bulbs, avoid
being burned by making sure they are
fully cooled.
Never drive the vehicle with the bulbs
not working. This could result in an
accident.
You and others could be seriously injured.
When one bulb of a pair of lamps, such as a
front turn signal lamp blows out, the other
bulb is approaching the end of its useful life.
We recommend that both be changed at the
same time.
The LED lights do not need to be replaced.
However, if you find anything abnormal
with the LED lights, see your dealer.
For the lamps (lighting equipment) such as
headlamps, inside of the lens can mist up
momentarily when driving in the rain or
during the car wash. Also, the temperature
difference between inside and outside of the
lamps can sometimes cause the water
condensation inside the lens. This is not
abnormal because this is the same
phenomenon as the windshield or door glass
fogs up when it rains. If the mist goes away
minutes after the lamp is turned on, things
are normal.