Chevrolet Low Cab Forward 6.7L 2022 Owner's Manual page 133

132 Driving and Operating
Keep the Floor Around the Driver's Seat
Clean and Tidy
Warning
It is extremely dangerous to have empty
cans, empty bottles or other items rolling
around on the floor because they could
get trapped under the brake pedal and
prevent brake application. For proper
pedal operation, it is also essential to lay
floor mats properly. Incorrectly installed
floor mats would hinder free movement
of the pedals.
Do not use the dashboard pocket or the
top of the dashboard as a place to put
items that could roll, which could
interfere with your driving. You and
others could be seriously injured.
Choose Your Footwear Suitable for Driving
Warning
Choose footwear that ensures proper
operation of pedals when driving the
vehicle. Use of footwear unsuitable for
driving may cause an accident.
Starting the Engine
Do not keep the engine control switch in
the START position for more than about
10 seconds. Operating the starter for too
long might cause starter and battery failure
or may result in overheating.
When the engine does not start, wait for 20
to 30 seconds and then turn the engine
control switch again.
If your vehicle is equipped with a selector
lever with P-range, before starting the
engine, sit in the driver's seat, check that
parking brake is engaged, the selector lever
is in the "P" or "N" ("P" is preferred) position
and the shift indicator also shows "P" or "N",
and firmly press the brake pedal to start the
engine.
If your vehicle is equipped with a selector
lever without P-range, before starting the
engine, sit in the driver's seat, check that
parking brake is engaged, the selector lever
is in the "N" position and the shift indicator
also shows "N", and firmly press the brake
pedal to start the engine.
For models with P-range, start the engine
with the selector lever in the "P" position
when stopped on a slope.
When stopped on a slope, start the engine
with the selector lever in the P position. See
Ignition Positions 0 130.
1. Make sure that the selector lever is in
the "P" (only models with P-range) or "N"
position and firmly press the brake
pedal.
2. When the engine control switch is
turned to the ON position, the wait to
start light comes on and then goes out
between 1 and 30 seconds later
depending on whether the engine is
warm or cold.
3. After confirming that the wait to start
light has gone out, turn the engine
control switch to the START position to
start the engine. Release the engine
control switch as soon as the engine
starts.