MAINTENANCE AND SERVICE
SERVICE
INTERVAL
Sweeper
•
•
•
Rotor
•
Cultivator
•
•
•
Rotor
•
Rotary mower
•
•
•
TROUBLESHOOTING
PROBLEM
The equipment
does not rotate
Poor sweeping
result
Rotor mower cuts
poorly
Before each run
While driving
After each run
Every 20h operating
hours
Before each run
While driving
After each run
Every 20h operating
hours
Before each run
While driving
After each run
CAUSE
- The equipment is not
properly connected.
- The connection is incor-
rectly adjusted
- The broom incorrectly set
- Sweeper RPM is too low
- The knife is unsharp
•
Check that there is nothing stuck in the
sweeper
•
Listen for noises
•
Flush with water if necessary
•
Lubrication
•
Check all blades. Replace any defective
blades. Sharp blades yield better results.
When replacing, bolts are tightened
properly
•
Listen for noises
•
Clean and lubricate the moving parts
•
Lubrication
•
Check all blades. Sharpen the blades if
necessary.
•
Listen for noises.
•
Clean and lubricate the blades
MEASURE
- Check that the equipment is properly
connected to the multi-machine.
- Check the clutch, adjust.
(See multi-user machine manual)
- Check the RPM and brush setting,
adjust the brush lever. The distance be-
tween the brush and the ground should
not be less than 3 cm.
- Make sure the blade and sharpen if
necessary.
9