Mitsubishi Electric MECH-iS-G07 Instructions For Installation, Use And Maintenance Manual page 85

9 MAINTENANCE
Check correct operation of compressor oil case resistance
Check dielectric rigidity
Check and calibrate correct operation of evaporator
flow switch and condenser / recuperator
Pump seal / gasket check
Check concentration of glycol solution where appropriate
Check and clean water filter at water heat exchanger inlet
* The frequency of the operations described in the table above should be considered indicative. In fact, it may undergo variations
according to the method of use of the unit and the system in which the latter is required to operate.
For units installed in aggressive climates, request air exchangers with a protective covering. In such climates the maintenance intervals
must be reduced (to be evaluated according to the specific climatic condition).
Installation, use and maintenance manual - Translation of the original instructions
Operation description
Table 10: frequency of maintenance activities.
Preliminary
Frequency*
3/4 6
months months months
●
●
●
●
●
EN
12
●
85