Mitsubishi Electric MECH-iS-G07 Instructions For Installation, Use And Maintenance Manual page 81

8 COMMISSIONING AND ADJUSTMENTS
This opens a screen showing the Operating Mode details:
Scrolling through the same screen, it is also possible to view the various customisable Setpoints of the unit:
To change the Operating Mode, using the dedicated selector select the desired operating mode among those available for the unit.
A pop-up window appears, confirming the change of operating mode, and the change command will be sent to the unit:
After a few seconds, the unit will switch to the selected operating mode.
Installation, use and maintenance manual - Translation of the original instructions
21.04.06
TIME BANDS ACTIVE
17.29.07
OPERATIVE MODE AND SETPOINT
OPERATIVE MODE
IN °C OUT °C
ON
19.4 15.7
from
KIPlink
Figure 8.15: operating mode
21.04.06
TIME BANDS ACTIVE
17.29.07
COOL SETPOINT HEAT SETPOINT
8.6 °C 35.0
5.0 15.0 30.0
8.6 38.0
°C
RECOVERY SET
35.0 °C
30.0 50.0
IN °C OUT °C
ON
19.4 15.7
from
KIPlink
Figure 8.16: unit setpoint.
21.04.06
TIME BANDS ACTIVE
17.29.07
ATTENTION!
You are about to change unit operating mode. Do you really want to?
Cancel Change
Figure 8.17: confirmation of the operating mode change.
19.4°C
19.4°C
°C
55.0
°C
19.4°C
You are about to change unit operating
mode. Do you really want to?
Preliminary
19.4°C 19.4°C
OPERATIVE MODE AND SETPOINT OPERATIVE MODE AND SETPOINT
OPERATIVE MODE OPERATIVE MODE
IN IN °C °C OUT OUT °C °C
19.4 19.4 15.7 15.7
19.4°C
COOL SETPOINT
5.0 8.6 °C 15.0
8.6
°C
HEAT SETPOINT
IN °C OUT °C
19.4 15.7
19.4°C
ATTENTION!
Cancel
Change
EN
81