Presence Of The Illuminated Unit On/Off Button; Unit Operating Mode And Setpoint Setup - Mitsubishi Electric MECH-iS-G07 Instructions For Installation, Use And Maintenance Manual

8 COMMISSIONING AND ADJUSTMENTS
A screen will appear, asking to confirm that you want to switch on the unit ("Switch on"), or cancel the operation ("Cancel"). The same
procedure is required for switching off.

8.9.1.1 Presence of the illuminated unit ON/OFF button

Units configured with KIPlink that do not have a physical keyboard have instead a function button, as shown in the image below, for
switching the unit on/off and viewing the power and alarm status of the unit.

8.9.2 Unit operating mode and Setpoint setup

To change the unit unit operating mode and the Setpoint proceed as follows: in the Homepage, select the "Operating Mode and Setpoint"
icon/button, or from any other screen select the "Quick Menu", followed by the "Operating Mode and Setpoint" icon/button.
Installation, use and maintenance manual - Translation of the original instructions
21.04.06
TIME BANDS ACTIVE
17.29.07
ATTENTION!
You are about to change unit operating mode. Do you really want to?
Cancel Change
Figure 8.12: confirmation pop-up.
[Power LED]
Steady white: indicates the unit is powered up.
[Unit status LED]
Green: the button has been pressed and it has closed the contact in series with the digital input
ON/OFF contact entering the controller*.
Red: there is at least one active alarm on the unit**.
Green/Red: the button has been pressed and it has closed the contact in series with the digital
input ON/OFF contact entering the controller* and there is at least one active alarm on the unit**.
[ON/OFF key]
It switches the unit ON/OFF, closing a contact in series with the ON/OFF contact connected to
the digital input.
Figure 8.14: access to the "Operating mode and Setpoint" menu.
19.4°C
ATTENTION!
You are about to change unit operating
mode. Do you really want to?
Figure 8.13: illuminated button.
Preliminary
19.4°C
Cancel
Change
EN
80