Mitsubishi Electric MECH-iS-G07 Instructions For Installation, Use And Maintenance Manual page 82

8 COMMISSIONING AND ADJUSTMENTS
To change the Setpoint parameters, select the temperature to set between:
• Main Set (cold Set and if applicable hot Set).
• Recovery / DHW Set.
Then click the corresponding box and enter the desired Setpoint value using the relevant pop-up window.
To confirm the value, press the appropriate "Send" icon/button
Installation, use and maintenance manual - Translation of the original instructions
The Operating Mode must be changed with the unit switched off. If the unit is on, a pop-up window appears,
warning the user that the change must be performed with the machine powered but switched OFF.
Figure 8.18: unit shutdown warning.
21.04.06
TIME BANDS ACTIVE
17.29.07
INSERT VALUE
°C
8.6
5.0 5.0 15.0
Figure 8.19: setpoint value change.
CAUTION
or to exit without confirming, press the "Cancel" icon/button or button.
19.4°C
Preliminary
19.4°C
INSERT VALUE
°C
8.6
5.0 5.0 15.0
SEND
EN
82