Maintenance & Care; Manufacturer's Warranty - STEINEL L 830 LED iHF Manual

Note:
After the light switches OFF, it takes approx. 1 second before it is able to start
detecting movement again. The light will only switch ON in response to
movement once this period has elapsed.
The shortest time setting is recommended when adjusting the detection zone
and performing the functional test.
Reach setting (sensitivity) (Fig. 6.2/E)
Reach is the term used to describe the diameter of the more or less circular
detection zone produced on the ground after mounting the sensor-switched
light at a height of 2 m.
– Control dial set to maximum = max. reach (5 m)
– Control dial set to minimum = min. reach (1 m)
Twilight setting (response threshold) (Fig. 6.2/F)
The chosen response threshold can be infinitely varied from approx. 2 to
1000 lux.
– Control dial turned fully clockwise = daylight mode (depending on ambient
brightness)
– Control dial turned fully anti-clockwise = twilight operation (approx. 2 lux)
The control dial must be turned fully clockwise when adjusting the detection
zone and performing the walk test in daylight.
Night-light function (Fig. 6.2/G)
The night light provides illumination at approx. 10% of full light output. The light
only switches to maximum output (100%) in response to movement in the
detection zone (see Time setting). The light
then switches to the activated night light level.
Night light is ON when the level of light falls below the brightness threshold.
Night light is always ON when daylight mode is activated.
0 min = soft light start / no night ON from twilight setting selected
10 min = soft light start + night light for 10 minutes
30 min = soft light start + night light for 30 minutes
= soft light start + night light all night long
What is soft light start?
The sensor-switched light features a soft light start function. This means that
when turned ON, the light is not switched directly to maximum output but con-
stantly builds up brightness to 100% within a short period of time. Brightness is
also gradually reduced when the light is switched OFF.
- 36 -
Manual override function
If an optional mains switch is installed in the mains supply lead, the following
functions are available in addition to simply switching light ON and OFF:
Manual override (Fig. 6.3)
1) Activate manual override:
Switch OFF and ON twice. The light is set to manual override for 4 hours. Then
it returns automatically to sensor mode.
2) Deactivate manual override:
Switch OFF and ON once. Light switches OFF or switches to sensor operation.
Important: Switching must take place within 0.2 to 1 second.
7. Maintenance / care
The product requires no maintenance.
The light can be cleaned with a damp cloth (without detergents) if dirty.
8. Disposal
Electrical and electronic equipment, accessories and packaging must be
recycled in an environmentally compatible manner.
Do not dispose of electrical and electronic equipment as domestic
waste.
EU countries only:
Under the current European Directive on Waste Electrical and Electronic Equip-
ment and its implementation in national law, electrical and electronic equipment
no longer suitable for use must be collected separately and recycled in an
environmentally compatible manner.

9. Manufacturer's warranty

This Steinel product has been manufactured with utmost care, tested for
proper operation and safety and then subjected to random sample inspection.
Steinel guarantees that it is in perfect condition and proper working order. The
warranty period is 36 months and starts on the date of sale to the consumer.
We will remedy defects caused by material flaws or manufacturing faults. The
warranty will be met by repair or replacement of defective parts at our own dis-
cretion. The warranty shall not cover damage to wear parts, damage or defects
caused by improper treatment or maintenance. Further consequential damage
to other objects shall be excluded.
- 37 -