Power Supply; Charging Time And Available Recording Time - Panasonic Palmcorder MultiCam PV-VM202 Operating Instructions Manual

Digital video camcorder
Table of Contents

Advertisement

Available languages

Available languages

1
2
POWER
CHARGE
QUICK
100%
1
A
CGA-D07
B
A
CGR-D08A/1B
B
A
CGR-D16A/1B
B
CGR-D53A/1K
A
B
12

Power Supply

ª Using the AC Adaptor
1
2
3
≥Before disconnecting the power supply, set the [OFF/ON/MODE] Switch on
the Palmcorder to [OFF].
≥Battery cannot be charged if DC Cable is connected to AC Adaptor.
1
3
ª Using the Battery
Before use, fully charge the battery.
1 1 1 1
2 2 2 2
Disconnecting the Power Source
Set the [OFF/ON/MODE] Switch
Lever to the right
MODE
OFF ON
CAMERA
≥When attaching or removing battery, set [OFF/ON/MODE] Switch to
VCR
CARD P. B.
POWER
[OFF] and make sure the Operation Mode Lamp is not lit.
2
≥For other notes, see page 60.
3

Charging Time and Available Recording Time

A Charging Time
B Maximum Continuous Recording Time
1 h 10 min.
≥"1 h 20 min." indicates 1 hour and 20 minutes.
1 h.
≥Battery CGA-D07 is supplied.
(55 min.)
≥The hours shown in the table are approximate hours. The numeric
1 h.
characters in parentheses indicate the recording time when the LCD
1 h 15 min.
monitor is used. In actual use, the available recording time may be shorter
(1 h 5 min.)
in some cases.
≥The hours shown in the table are for continuous recording at a temperature
1 h 10 min.
of 68xF (20xC) and humidity of 60 %. If the Battery is charged at a higher or
2 h 30 min.
lower temperature, the charging time may be longer.
(2 h 5 min.)
4 h 30 min.
8 h 15 min.
(6 h 45 min.)
Insert the battery-shaped connector of the DC Cable into the
Battery Holder on the Palmcorder.
Connect the DC connector plug to the [DC OUT] Jack on the
AC Adaptor.
Connect the AC Adaptor and AC Cable.
Attach the Battery to AC Adaptor and charge it.
≥Since the Battery will not be charged when the DC Cable is connected
to the AC Adaptor, disconnect it.
≥After the [POWER] Lamp has lighted, the [CHARGE] Lamp flashes.
When the [100%] Lamp
Attach the charged Battery to the Palmcorder.
3
, and then slide the Battery to remove it.
~~~~~~~~~~~~~~~~~~~~~~~~
A lithium ion/polymer battery that is recyclable
powers the product you have purchased.
Please call 1-800-8-BATTERY for information
on how to recycle this battery.
1
1
on the AC Adaptor is lit, charging is finished.
2
to [OFF], and the [BATTERY EJECT]
ATTENTION:

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pvvm202d - digital video camcor

Table of Contents