Panasonic Palmcorder MultiCam PV-VM202 Operating Instructions Manual page 36

F 7
640
RESET
TAPE
1,
CARD
3,
36
ª Card PhotoShot (continued)
Recording from a Cassette (VCR Mode)
1
2
3
4
Recording from other equipment
1 1 1 1
2,
2 2 2 2
STILL MPEG4 VOICE
CARD
3 3 3 3
MODE
OFF ON MODE
CAMERA
4 4 4 4
VCR
CARD P. B.
POWER
ACCESS
Selecting the quality of Card PhotoShot images
W.B./SHUTTER/IRIS/
MF/VOL/JOG
1
2 1
PUSH
3,
Maximum number of images recordable on the supplied Card (16MB)
BACKLIGHT
4
When the picture size is 1200k k k k 900:
CAMERA
STILL
[FINE] (high image quality):
[NORMAL] (Normal):
PHOTO [ECONOMY] (low image quality): approximately 65 pictures
SHOT
When the picture size is 640k k k k 480:
4,
[FINE] (high image quality):
[NORMAL] (Normal):
[ECONOMY] (low image quality): approximately 400 pictures
≥For other notes, see page 63.
Slide the [TAPE/CARD] Selector to [CARD].
Slide the [STILL/MPEG4/VOICE] Selector to [STILL].
Set [VCR FUNCTIONS] >> [CARD SETUP] >>
[PICTURE QUALITY] >> a desired picture quality.
Start playback and press the [PHOTO SHOT] Button at the
scene you want to record.
≥The size of the images input externally or recorded from a tape to the
card becomes [640k480].
≥While the image is being recorded, it stays still for a few seconds.
Set the [PICTURE QUALITY] on the [CARD SETUP]
Sub-Menu to desired picture quality.
Slide the [TAPE/CARD] Selector to [CARD].
Slide the [STILL/MPEG4/VOICE] Selector to [STILL].
Input the picture from the other equipment then press the
[PHOTO SHOT] Button at the desired scene.
Set [CAMERA FUNCTIONS] or [VCR FUNCTIONS] >>
[CARD SETUP] >> [PICTURE QUALITY] >> a desired picture
quality.
approximately 23 pictures
approximately 42 pictures
approximately 100 pictures
approximately 200 pictures