Table of Contents
Advertisement
Playback
(checking what has been recorded)
When the PLAY/PAUSE button is pressed, the
playback pictures can be monitored on the viewfinder
screen.
These playback pictures can be monitored in two
other ways.
Rec review
When recording is temporarily stopped and the lens
RET button is pressed, the last two seconds of the
tape are automatically rewound, and the playback
pictures on this part of the tape appear on the
viewfinder screen. This makes it possible to check
whether recording was performed properly.
After the two seconds of the tape have been played
back, the unit is again set to the recording start
standby mode.
If the RET button is held down, a maximum of 10
seconds of the tape is rewound and played back.
<Note>
The rec review function cannot be used unless
recording lasts for one or more seconds.
The functions of the RET button on the lens can be
assigned to the USER1 or USER2 button on the
unit's side panel on the CAM SW MODE screen of
FILM (CAM) MAIN MENU 2, and this button can
then be used to perform the return operations.
Lens RET button functions
Depending on the internal VTR status, the RET button
functions which appear on the viewfinder screen
change as follows.
Internal VTR
What appears on the viewfinder screen
status
During recording
Pictures which are shot by the camera
(RET button does not work)
During rec-
What has just been recorded (rec review of 2
pause
seconds of the tape recording) can be checked.
During playback
Playback pictures of internal VTR
(RET button does not work)
During play-
Pictures which are shot by the camera at that
pause
time; the same also applies during cue-up
operations for ensuring frame-to-frame continuity.
84
Color playback
When an HD color monitor is connected to the unit's
HD SDI MON connector, color playback pictures can
be monitored.
The playback signals will be output to the viewfinder
even during rewinding (REW) or fast forwarding (FF).
Selecting the audio output of the playback signal and
adjusting the volume are accomplished using the
MONITOR switch control (page 12).
The functions of the RET button on the lens can be
assigned to the USER1 or USER2 button on the
unit's side panel on the CAM SW MODE screen of
FILM (CAM) MAIN MENU 2, and this button can
then be used to perform the return operations.
Advertisement
Table of Contents
