Emerson Rosemount 1057 Quick Start Manual page 22

Quick Start Guide
• Output 3 mA
• Output 4 mA
• Output 1%
• Output 2%
• Output 3%
• Output 4%
• Measure 1, 2, 3
• Blank
Fault and Warning banner
If the transmitter detects a problem with itself or the sensor, the word Fault
or Warning will appear at the bottom of the display. A fault requires
immediate attention. A warning indicates a problematic condition or an
impending failure. For troubleshooting assistance, press DIAG.
Formatting the main display
You can program the main display screen to show primary process variables,
secondary process variables, and diagnostics.
1. Press MENU.
2. Scroll down to Display. Press ENTER.
3. Main Format is highlighted. Press ENTER.
4. The Sensor 1 process value is highlighted in reverse video. Press the
selection keys to navigate down to the screen sections that you wish
to program. Press ENTER.
5. Choose the desired display parameter or diagnostic for each of the
four display sections in the lower screen.
6. Continue to navigate and program all desired screen selections. Press
MENU and EXIT. The screen returns to the main display.
For single sensor configurations, the default display shows the live process
measurement in the upper display area and temperature in the center
display area. You can elect to disable the display of temperature in the
center display area using the Main Format function. See
you through programming the main display to select process parameters
and diagnostics of your choice.
22
February 2022
Figure 4-1 to guide
Emerson.com/Rosemount