Emerson Rosemount 1057 Quick Start Manual page 21

February 2022
4.3 Main display
The transmitter displays one, two, or three primary measurement values, up
to six secondary measurement values, a fault and warning banner, and alarm
relay flags.
Process measurements
Three process variables are displayed if three signal boards are installed. One
process variable and process temperature are displayed if one signal board is
installed with one sensor. The upper display area shows the Sensor 1 process
reading. The center display area shows the Sensor 2 process reading. For
dual conductivity, you can assign the upper and center display areas to
different process variables as follows:
• Measure 1
• Measure 2
• Measure 3
• % Reject
• % Pass
• Ratio
• Blank
• pH Calc
Secondary values
Up to six secondary values are shown in display quadrants at the bottom half
of the screen. You can program all six secondary value positions to any
displayable parameter available.
Possible secondary values include:
• Slope 1, 2, 3
• Ref off 1, 2, 3
• GI imp 1, 2, 3
• Ref imp 1, 2, 3
• Raw 1, 2, 3
• mV input 1, 2, 3
• Temp 1, 2, 3
• Man temp 1, 2, 3
• Output 1 mA
• Output 2 mA
Quick Start Guide
Quick Start Guide
21