Answering System Settings; Remote Code; Caller's Recording Time; Number Of Rings - Panasonic KX-TG2388 Operating Instructions Manual

Answering System Features
Skipping the greeting message to leave
a message
You can leave a message just as any
outside caller can. Call your phone
number, then press {*} to skip the
greeting message and record your
message after the beep.
Answering system
settings

Remote code

A remote code must be entered when
operating the answering system remotely.
This code prevents unauthorized parties
from listening to your messages remotely.
Store any 2-digit number (00–99).
1
Press {MENU}.
2
Scroll to "Initial setting" by
pressing {V} or {^}, then press
{Select}.
3
Press {Select} at "Set answering".
4
Scroll to "Remote code" by pressing
{V} or {^}, then press {Select}.
5
Enter a
2-digit remote code (00-99).
6
Press {Save}, then press {OFF}.
Note:
L To confirm the remote code, repeat
steps 1 to 4. Press {OFF} when finished.
54
For assistance, please visit http://www.panasonic.com/consumersupport

Caller's recording time

You can change the maximum message

recording time.

"1min", "2min", or "3min": Caller
messages are limited to 1 minute to 3
minutes.
"Greeting only": The unit plays the
greeting message but does not record
caller messages.
1
Press {MENU}.
2
Scroll to "Initial setting" by
pressing {V} or {^}, then press
{Select}.
3
Press {Select} at "Set answering".
4
Scroll to "Recording time" by
pressing {V} or {^}, then press
{Select}.
5
Select the recording time by pressing
{V} or {^}.
L You can also select the recording
time by pressing {1}, {2}, {3} or {0}
(Greeting only).
6
Press {Save}, then press {OFF}.
If you select "Greeting only", the
unit will answer calls with the greeting
message, and then hang up. The unit
will not record any incoming messages.
The base unit will display "
of the number of messages.

Number of rings

You can select the number of times the unit
rings before the Answering System
answers a call, from "2" to "7" or "Toll
saver"*.
1
Press {MENU}.
2
Scroll to "Initial setting" by
pressing {V} or {^}, then press
{Select}.
3
Press {Select} at "Set answering".
" instead