Answering System Settings - Panasonic KX-TGF372AZS Operating Instructions Manual

Digital cordless phone with dual keypad and link-to-mobile
Table of Contents

Advertisement

4
When finished, hang up.
Voice guidance
During remote operation, the unit's voice
guidance starts and prompts you to press 1
to perform a specific operation, or press 2 to
listen to more available operations.
Note:
R If you do not press any dial keys within 10
seconds after a voice guidance prompt, the
unit disconnects your call.
Remote commands
You can press dial keys to access certain
answering system functions without waiting for
the voice guidance to prompt you.
Key
Operation
1
Repeat message (during
*1
playback)
2
Skip message (during playback)
4
Play new messages
5
Play all messages
9
Stop recording
Stop playback
0
Turn answering system off
*4
Erase currently playing message
*5
Erase all messages
*#
End remote operation
(or hang up)
*1
If pressed within the first 5 seconds of a
message, the previous message is
played.
Turning on the answering system
remotely
1
Dial your phone number from a
touch-tone phone.
2
Let the phone ring 15 times.
R A long beep is heard.
Answering System for Landline
3
Enter your remote access code within 10
seconds after the long beep.
R The greeting message is played back.
R You can either hang up, or enter your
remote access code again and begin
remote operation (page 66).

Answering system settings

Call screening
Handset / Base unit
While a caller is leaving a message, you can
listen to the call through the unit's speaker.
To adjust the speaker volume, press MDN or
MCN repeatedly.
You can answer the call by pressing M
the handset or MZN on the base unit.
Call screening can be set for each unit. The
default setting is "On".
1
MMENUN#310
2
MbN: Select the desired setting. a
MSAVEN
3
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Number of rings before the unit
answers a call
You can change the number of times the
phone rings "Ring count" before the unit
answers calls. You can select 2 to 9 rings, or
"Toll saver".
The default setting is "5 rings".
"Toll saver": The unit's answering system
answers at the end of the 2nd ring when new
messages have been recorded, or at the end
of the 5th ring when there are no new
messages. If you call your phone from outside
to listen to new messages (page 66), you
know that there are no new messages when
the phone rings for the 3rd time. You can then
hang up without being charged for the call.
N on
67

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kx-tgf372az

Table of Contents