Polycom RMX 1000 Started Manual page 9

Parameter
Use LAN1
DHCP
IP Address
Subnet Mask
Gateway
NAT
Obtain DNS server
address automatically
Preferred/Alternate
DNS Server
LAN Speed
Description
Enables/disables the network port
If the user network is configured with a Dynamic
Host Configuration Protocol (DHCP) server,
select this option to automatically obtain the IP
address.
Deselect this option to use a static IP address,
in which case you need to configure the next
three options.
Set the IP address for this network port
Set the subnet mask for this network port
Set the gateway address for this network port. If
the Set as Default option is selected, the de-
vice packet will be forwarded through this
gateway by default when there is no matched
static route. In this case, a default route is dis-
played in the list of the Advanced Setting ->
Router page.
The Network Address Translation (NAT) func-
tion enables you to translate a private network
IP address into a public network IP address
before transmission. To enable NAT, select this
box and then type the public network IP address
to be displayed to the outside.
Used in combination with the DHCP option.
When the DHCP check box is selected, this
option allows you to obtain the DNS server ad-
dress automatically from a DHCP server in the
network.
If you did not select the option for automatic
DNS address discovery, you must enter the
preferred/alternate DNS server addresses here
for the device to resolve domain names.
Sets the speed/duplex modes for LAN ports.
9