Table of Contents
Advertisement
Project Planning Manual | Rexroth IndraControl VAU01.1S
3.8
Protection Against Magnetic and Electromagnetic Fields Dur‐
ing Operation and Mounting
WARNING
3.9
Protection Against Contact with Hot Parts
CAUTION
3.10
Protection During Handling and Mounting
CAUTION
Magnetic and electromagnetic fields generated by current-carrying conductors
and permanent magnets in motors represent a serious personal danger to
those with heart pacemakers, metal implants and hearing aids.
Health hazard for persons with heart pacemakers, metal implants and
hearing aids in proximity to electrical equipment!
●
Persons with heart pacemakers and metal implants are not permitted to
enter following areas:
–
Areas in which electrical equipment and parts are mounted, being
operated or commissioned.
–
Areas in which motor parts with permanent magnets are stored, re‐
paired or assembled.
●
If it is necessary for somebody with a pacemaker to enter such an area,
a doctor must be consulted prior to doing so. The noise immunity of pres‐
ent or future implanted heart pacemakers differs greatly so that no general
rules can be given.
●
Those with metal implants or metal pieces, as well as with hearing aids,
must consult a doctor before they enter the areas described above. Oth‐
erwise health hazards may occur.
Hot surfaces on device housing! Danger of injury! Danger of burns!
●
Do not touch the surface of housings near sources of heat! Danger of
burns!
●
Before touching first allow devices to cool for ten minutes after switching
off.
●
Touching hot equipment parts such as device housings in which heatsinks
and resistors are located can lead to burns!
In unfavorable conditions, handling and mounting certain parts and compo‐
nents in an improper way can cause injuries.
Risk of injury by improper handling! Bodily injury by bruising, shearing,
cutting, hitting!
●
Observe the general construction and safety regulations on handling and
mounting.
●
Use suitable devices for mounting and transport.
●
Avoid jamming and bruising by appropriate measures.
●
Always use suitable tools. Use special tools if specified.
●
Use lifting equipment and tools in the correct manner.
●
If necessary, use suitable protective equipment (for example safety gog‐
gles, safety shoes, safety gloves).
●
Do not stand under hanging loads.
●
Immediately clean up any spilled liquids because of the danger of skidding.
Electric Drives
| Bosch Rexroth AG
and Controls
Safety Instructions for Electric Drives and Controls
11/43
Advertisement
Table of Contents
