Table of Contents
Advertisement
Videojet connect 7000
5.1
Mounting
3. Mount the device to a stable surface, if desired.
–
–
–
Figure 5.1: Dimensions, mounting holes, VIDEOJET connect 7000
Notice!
If you are securing the enclosure in a vertical position (for example, on a wall), one person
should hold the enclosure lid while another person secures the enclosure body in place, to
avoid damage to any part of the enclosure, and/or injury to the installers.
Bosch Security Systems
Locate the four (4) mounting holes.
If applicable, drill four (4) holes in the mounting surface for the mounting anchors
appropriate for M6 screws, using the figure below as reference.
Secure the enclosure to the mounting surface using four (4) M6 stainless steel screws
and washers (not supplied), which fit through the large holes in the enclosure.
Installation Manual
Installation | en
19
2019-08 | 1.7 | F.01U.291.524
Advertisement
Table of Contents
