Table of Contents
Advertisement
5.
Select the combustion
Management.
6.
Once all the previous checks have been carried out, we will proceed to the ignition of the boiler as
in section 6.1.1 On - Off of the Hidromatic Boiler. At this time the plate performs a check of the boiler
"Check" during which it will perform several verifications. If during this check the electronic board detects
any anomaly it will not start and will give the corresponding error message. If everything is correct, the
boiler will start with the ignition process.
7.
7. At the time of ignition, an error message
9. Problems, messages and alarms to know how to act, since while we have an error on the screen we will not
be able to start the boiler.
8. CLEANING AND MAINTENANCE
For the proper functioning of the boiler it is essential to carry out certain maintenance tasks, the frequency of which will
depend mainly on the hours of operation and the quality of the fuel. Some must be done daily, while there are others that it
is enough to do them once a season.
It is responsible for the user
some performing them directly, and others by notifying a professional or S.A.T. authoritative.
When the message "Clean"(Reset Service)appears on the screen, the user must perform the cleaning as shown in section
6.1.2. Settings - Reset Service. Then
section 6.1.2. Settings - Reset Service.
RESET SERVICE
Reset Service
power
of the boiler as it appears in section 6.1.2 Configurations - Combustion
to ensure
that the necessary cleaning and maintenance operations are carried out,
we show again the sequence for the reset of this message as also shown in
08:36 Thu 09 Sep 2021
Reset Service
may also appear. In this case we will consult the equipment
º
Clean
º
Reset Service
37
Reset Service
explained
Advertisement
Table of Contents
