Finnleo NorthStar Indoor Series Owner's Manual page 10

34. Assemble wood heater guard before installation using the screws and
wooden buttons provided. Use the two spacing blocks as a guide for
installation. Place one block horizontally on the floor and the other
stacked vertically on top. Install the wood heater guard around the sauna
heater using the 1 1/8" screws provided.
35. Rinse the rocks of dirt and dust. Install the rocks into the heater. Place small or flat rocks around the
outer perimeter of heat chamber, including the ends. Place larger rocks loosely in middle of heater.
Fill the heater until flush with the top of the outer shroud. Add 3 to 4 large rocks to top of heater.
*Note: There will be extra rocks provided. The concept of rock placement is to promote good airflow
through the heater.
*Note: Use only the "olivine" sauna rocks provided with the
heater. If other rocks are used, the warranty is void.
Never operate the heater without rocks.
36. Install the rock grill to the top of the heater with the two
screws.
37. Place cover on CB Box with the four screws provided.
38. Connect the control wire from the front wall to the control.
71-0163
Rev. 01
39. Use a flat-blade screwdriver to carefully pry the front
glass off the control body.
Page 10 4215-138
09/07/2021