Finnleo NorthStar Indoor Series Owner's Manual page 9

24. After all connections, mount the CB Box to the back wall with the four screws provided in the
hardware pack inside the CB box.
25. Install plastic wire raceway on right side wall. Peel adhesive strip off the back side of raceway and
attach to the wall, flush with the floor and about 12" from the front of the room. Make sure the open
slot is facing up so wires can be inserted.
26. Hang heater on front wall. Use the information from the sauna heater installations.
27. Remove the rock grill from the heater. Remove the two screws on the top back of heater.
28. After removing the screws for the rock grill, the mounting
bracket will be loose from the heater.
29. Secure the sauna heater-mounting bracket to wall brackets
using the in-predrilled holes.
30. Hang the heater on the mounting bracket tabs.
32. Insert the sensor and control cables into wire raceway, one
cable at a time, and orientate them so they are on top of the
large power cable and positioned towards the back of the
raceway.
33. When all the cables are in the raceway, seal the raceway shut by starting at one end and snapping the
"cover" shut as you move towards the opposite end. If the cover will not close you may need to re-
orientate the wires.
71-0163
Rev. 01
31. Insert the large black main power cable into the open
slot of the wire raceway.
Page 9
Open slot facing up
4215-138
09/07/2021