Finnleo NorthStar Indoor Series Owner's Manual page 11

40. Install two of the shorter screws to the control. Place a black plastic wing on the end of each screw.
(Longer screws are not used)
41. Mount control on to wall so the wires are inside the wall. Secure control to wall with the previously
installed screws and wings. Place glass cover on control.
42. Temporarily connect the backrest to the back wall.
43. Ensure all electrical connections are installed and everything is safe.
44. Apply power to the heater. The control will flash for about 15 seconds as it is booting up.
45. Press the room light button to ensure backrest lights turn on.
46. Press the On button and allow heater to run for 15 seconds, then turn off.
47. Put your hands close to the elements (DO NOT TOUCH) to feel if all three elements are heating. Or,
have the electrician verify the correct Amp draw for your heater.
48. Confirm everything is working. After confirmation, do the final installation of the control and install
rocks in the heater.
71-0163
Rev. 01
Page 11 4215-138
09/07/2021