Finnleo NorthStar Indoor Series Owner's Manual page 7

11. Place the ceiling panel on the room.
12. Fasten ceiling panel down to the wall panels using 3" screws.
Note: Ceiling panel is designed ¼" smaller than the opening. Make sure
the top of the sauna walls is square with the ceiling panel.
Note: Trim is sent long and needs to be trimmed onsite for proper fit.
13. Nail fascia trim to the exterior back wall so it is flush
to the left and right edges of the wall.
Note: The fascia top should be flush with the top of
the wall panel.
14. Install fascia to the side walls so it is flush to the back
fascia and the edge of the front wall.
15. Install fascia to the front wall so it is flush to the left
and right-side fascia.
16. Install interior cove to front wall so it lays flush to left and right
edges of the wall.
17. Install cove to back wall so it lays flush to left and right edges of
wall.
18. Install cove to left and right side walls so it lays flush to front
cove and back cove.
71-0163
Rev. 01
Page 7 4215-138
09/07/2021