Table of Contents
Advertisement
3 - Introduction
EN
3.1 - Precautions
Quick
Thrusters have been designed and constructed only for nautical use.
®
• Do not use these products for any other type of operation.
• Quick
shall not be held liable for direct or indirect damage caused by improper use of the product.
®
• The product is not designed to support loads generated in particular atmospheric conditions (storms).
• Operate the product from a position where it is possible to supervise the work area.
• Always deactivate the product when not being used.
• For improved safety, we recommend installing at least two controls to operate the product in case one is damaged.
• The installer shall bear full responsibility for any problems caused by defective installation of the tunnel.
• This equipment is not intended for use by people (including children) with reduced physical, sensory or mental capabilities.
• Do not install the electric motor near easily inflammable objects.
3.2- Precautions for the installer
CARRY OUT THE INSTALLATION IN GOOD LIGHTING CONDITIONS.
It is advisable to wear suitable clothing and personal protective equipment (PPE).
The product is not suitable for installation in potentially explosive environments and/or atmospheres.
Installation and subsequent inspection or repair work must only be carried out by qualified personnel.
CARRY OUT INSTALLATION/MAINTENANCE WORK MAKING SURE THAT THE PRODUCT IS DISCONNECTED
FROM THE ELECTRICAL SYSTEM.
Quick
accepts no responsibility for inadequate connection of users to the electrical system and inadequate safety of
®
the electrical system.
3.3 - Installation requirements
We recommend you entrust preparation and positioning of the tunnel in the hull to a skilled professional.
These are generic instructions and do not give details of the preparatory operations for installing the thruster, since this is the
competence of the boatyard. The installer shall bear full responsibility for any problems caused by defective installation.
Although all the components and mechanical moving parts are of high quality, the correct installation of the driving unit is an
essential basis for the safe and effective use of the boat as well as the driving unit itself.
The installation of such a unit is an operation that requires experience as well as technical skills. It is recommended that the
installation be carried out by competent personnel and that the manufacturer or naval architects be consulted to fully assess
the scope of the work.
8
The terminals must be properly tightened.
Secure / hold the inner nut when tightening
MINIMUM TIGHTENING TORQUE IS 11 Nm
QUICK BTQSeries INSTALLATION AND USER'S MANUAL - REV003A
BTQ Series
Hide quick links:
Advertisement
Table of Contents
