Table of Contents
Advertisement
4 - Installation
4.4 - BTQ 140/185/250/300 Gearleg and motor support flange
• Fit the gearleg with the special seal gasket.
• For further protection against the entry of water, apply
silicone for nautical use around the point of contact between
flange and tube.
• Fasten everything with the flange using the special screws
and washers.
1
3
4.4.0 - BTQ140/185/250/300 Single propeller/double propeller assembly
PIN
B
Propeller(s) assembly
Insert the drive key/pin A on gearleg B; fit the propeller C to the
gearleg by engaging it to the drive key/pin A; secure the propeller
with the self-locking nut D. Insert anode E on nut D and lock it with
screw F smeared with threadlocker (loctite type).
• Grease the terminal part of
the gearleg shaft; fit the small
key into its seat.
• Grease the terminal part of
the drive shaft; fit the key into
its seat.
A
D
C
D
E
F
QUICK BTQSeries INSTALLATION AND USER'S MANUAL - REV003A
2
4
KEY
A
F
E
D
C
B
BTQ Series
• Insert the elastic coupling
in the terminal part of the
gearleg shaft.
• Insert the motor onto the
elastic coupling; secure
it with the 4 screws and
washers supplied.
A
C
D
E
F
WARNING: on conclusion
of assembly, make sure
that the propeller is
exactly positioned at the
central point of the tunnel.
EN
13
Hide quick links:
Advertisement
Table of Contents
