Cautions & Use; Important Cautions; Thruster Use - Quick BTQ Series Installation And User Manual

Single and double propeller - electric motor

Hide thumbs Also See for BTQ Series:

Table of Contents

6 - Cautions & Use

• This thruster is not designed for continuous use. It is equipped with protections which limit its operation at

a maximum time span, as reported on the controls' manual. It is strongly forbidden to bypass or modify such

protections in order to increase the operating time span, lest voiding the warranty and thus lifting any responsibility

from Quick

• Make sure no swimmers or floating objects are in the vicinity before switching on the thruster.

• There must not be flammable materials in the peak or in the area where the Thruster motor is.

• Do not operate the bow thruster out of the water for more than 10 seconds.

• During mooring, it is recommended not to leave in the water any free line, which may be sucked in by the

propellers, thus leading them to break.

SINGLE PROPELLER

NOTE: the bow thruster must be installed with the propeller

to the right of the gearleg (see figure).

If it is necessary to install the bow thruster in the opposite

position, the connection of the two cables (blue and grey)

of the control cable on the reversing contactor must be

reversed.

Start-up

Start-up happens following activation of a TCD panel.

To use the propeller, refer to the TCD control manual.

SPA.

QUICK BTQSeries INSTALLATION AND USER'S MANUAL - REV003A

DOUBLE PROPELLER

NOTE: the bow thruster must be installed with the RH

propeller to the right of the gearleg (see figure).

BTQ Series

Table of Contents

Show Quick Links

Table of Contents