Fieldmann FZP 2025-E Manual page 29

Filing the depth gauge
As a result of sharpening the teeth on the chain, the depth
gauge tolerance is reduced. After every second or third sharpen-
ing, it is necessary to adjust the depth gauge setting.
Place the depth gauge adjustment jig (see fi g., point 1)
fi rmly on the top edge of two teeth. Make sure that the
groove of the jig is in the groove of the depth gauge (see
fi g., point 2.)
Use a medium-sized fl at fi le (see fi g., point 3).
File the depth gauge (see fi g., point 4) to the level of the
depth gauge adjustment jig.
Remove the depth gauge adjustment jig. Using a fl at fi le,
round the front edge of the depth gauge (see fi gure). When
fi ling, adhere to the prescribed values (see fi g., point 5).
Note: After the chain has been sharpened by hand
several times, have the saw chain sharpened at an
authorised service centre or sharpen it on a special
sharpening machine. This will renew the even sharpness
of all teeth.
ELECTRIC CHAIN SAW
Sharpening the saw chain
3
1
5
29 EN
4
2
0,6 mm
USER'S MANUAL