Maintenance - Daikin MCB50YSAU Installation & Operation Manual

Maintenance

Maintenance
Unit/Outflow grill
If dirt becomes an issue
• Wipe up dirt with a soft damp cloth.
• If dirt buildup is severe, wet a cloth with kitchen-use neutral detergent
and wipe up the dirt.
• Do not use a hard brush, etc. (Damage may result)
Dust/Particle sensor
If dust builds up
Vacuum cleaner
1 Remove the pre-filter (left-
side).
2 Vacuum off any dust using a
vacuum cleaner crevice tool or
similar.
1
Remove
hook
and pull
toward
you
Air intake for sensor
Pre-filter
(front, left-side, right-side)
About 1 time every 2 months
Vacuum cleaner
Wash with water
• After removing any dust using a
vacuum cleaner, remove and
wash the filter with water, then
dry thoroughly in the shade.
• Use a soft brush to clean the
spaces between the slats.
Attention
• Do not use a cotton swab or
hard scrubbing brush.
(Partial damage to the filter may result)
• Do not apply too much force.
(Partial damage to the filter and
scratching may result)
• If dirt buildup is severe, leave the
part soaking in lukewarm or room
temperature water mixed with
kitchen-use neutral detergent,
then throughly rinse so that no
detergent remains and leave in
the shade until completely dry.
17
Wipe
About 1 time every 3 months
Wipe
1 Remove pre-filter (left-side) and
the cover of the air intake for the
sensor.
2
Lens
Because it is difficult to see even
when illuminated with a light,
lightly rub with a dry cotton swab
along the left-side of the inside.
Vacuum off any dust around the area
using a vacuum cleaner crevice tool or
similar.
3 After cleaning, be sure to attach
the cover securely.
(Malfunction may result)
How to remove
Hold the
indentation of the
pre-filter and pull it
toward you to
remove it.
1 Put your thumb
on the unit and
hold the end of
the pre-filter.
2 Pull it toward
How to attach
Insert the hooks
(2 places) into
the unit, then
press until a
catching sound
is heard.
Hooks
(2 places)
Reverse side
Insert the hook
Hook (1 place)
(1 place) into the
unit.
Press both ends
Viewed from above
to securely
attach.
WARNING
Be sure to stop operation and unplug the power supply plug before
performing maintenance. (Electric shock or injury may result)
(Left-side)
UV unit
The UV unit cannot be cleaned.*
• Do not touch the UV
unit.
(Malfunction may
result)
* Cleaning is not required,
but if dirt becomes an
issue, it can be
replaced.
Contact your dealer or
the customer service
center.
you to remove it.
Attention
• Please observe to prevent discoloration and
deformation.
• If detergent was used, wipe thoroughly so that
no detergent remains.
• When using hot water, keep the temperature
below 104°F (40°C).
• Do not dry in direct sunlight.
• Do not dry with a hairdryer.
• Do not expose to fire.
• When using a vacuum cleaner, do not impact the
part with the vacuum cleaner.
(Damage may result)
(Right-
side)
(Front)
(inside)