Daikin MCB50YSAU Installation & Operation Manual page 19

WARNING
• Do not use gasoline, benzine, thinner, polishing compound, paraffin, alcohol, etc. (Cracking, electric shock, and ignition of fire may result)
• Do not wash the unit with water. (Electric shock and fire or malfunctioning may result)
Attention
Be sure to operate with a dust collection filter, and carbon filter unit attached.
If the unit is operated without the filters attached, malfunction may result.
Carbon filter unit
When dirt becomes
an issue
• Remove the entire frame from the unit, then
vacuum away dust using a vacuum cleaner.
• If odor becomes a problem, expose to airflow in
a shady place. (Approx. 1 day)
• Do not rub the surface.
• Do not wash with water. (If you wash it with
The carbon filter unit
water, it will lose its shape and you will not be
acts as a safety
able to use it.)
switch, because if it
is removed, UV
emission is
impossible.
After cleaning, be
sure to attach it
before operation.
• If odor and dirt are still an issue even after
cleaning, replace it.
About purchase and disposal
• Refer to "Replacement Parts"
• For the attachment method, refer to "Attaching
the carbon filter"
Dust collection filter
About replacement timing
• When the filter replacement lamp lights up,
there is about 1 month remaining before
replacement is necessary.
• When the filter replacement lamp blinks,
replace the dust collection filter with a new one.
Please consider replacing the carbon filter at
the same time.
After replacing the dust collection filter with a
Dust collection filter
new one, press and hold
simultaneously for about 2 seconds to reset the
filter replacement alert.
(Two short beeps will sound, and the filter
replacement lamp will turn off.)
About purchase and disposal
• Refer to "Replacement Parts"
Note
• The replacement timing of the dust collection
filter depends on how it is used and the usage
environment.
Cannot be washed with water
When odor and dirt
becomes an issue
Vacuum cleaner
Expose to air flow
in a shady place
►Page 21
Do not remove the carbon
filter from the frame
►Page 11
Cannot be washed with water
Replace
Do not vacuum clean
and
How to remove
Hold the lever of the carbon filter unit and the grip,
and pull it out.
How to attach
Push the carbon filter unit all the way in.
• If the carbon filter unit or the carbon filter is not
attached properly, the odor sensor lamp or
the UV ON/OFF lamp blinks.
►Page 25
How to remove
1 Remove the carbon filter unit.
2 Lift the tag of the dust
collection filter up.
How to attach
1 Paying attention to the orientation, install a
new dust collection filter.
The side with the tag and
marking is the front side,
and the tip of the arrow
points to the top side
►Page 25
2 Attach the carbon filter unit.
Maintenance
Lever
Grip
Press until a catching
sound is heard
3 Hold the bottom of the dust
collection filter and pull it out.
Dust collection filter
18