Daikin MCB50YSAU Installation & Operation Manual page 17

2
Press to change the setting*
Each press cycles between "Low",
"Normal", "High".
"Low"
"Normal"
"High"
Press to change the setting*
Each press cycles between "ON" and
"OFF".
"ON"
[Lit up]
"OFF"
[Unlit]
Press to change the setting*
The airflow rate switches between
"4 levels" and "3 levels" with each press.
"4 levels"
[Unlit]
"3 levels"
[Lit up]
* If the lamps do not change even after the settings were changed, unplug the unit, wait at least 5 seconds, then re-insert the power supply plug
and repeat the above procedure from the beginning.
3
Press
1 short beep will sound and the set FAN
lamp will blink.
"Low"
"Normal"
"High"
Press
A short beep sounds and the FAN lamp "Quiet"
blinks, and the ECONO MODE lamp changes
as below according to the current setting.
[Blinking]
"ON"
[Blinking]
"OFF"
[Unlit]
Press
A short beep sounds and the AUTO FAN
MODE lamp blinks, and the FAN lamp
changes as below according to the setting.
[Blinking]
"4 levels"
[Unlit]
"3 levels"
[Blinking]
Advanced Settings
4
While the lamp is blinking,
unplug the power supply
plug, wait at least
5 seconds, and then insert
the power supply plug
again.
Setting is now complete.
Power supply
plug
Power socket
• If this procedure is not performed,
the unit will not return to regular
operation mode.
• Settings are remembered even if the
unit is unplugged.
16