Safety instructions
Important
Please read the safety instructions carefully before using this router.
Warning
Electrical voltage on power supply, telephone and network
cables is dangerous! Failure to observe the safety instructions can
lead to dangerous situations, which can also result in severe injury or
death.
To prevent personal injury and damage to property as well as danger
to domestic animals and livestock, the following must be observed
when installing and operating the be.IP swift:
The router must not be opened.
•
Do not install the router or connect or disconnect any lines
•
during a thunderstorm.
Operation is only intended for dry rooms inside buildings.
•
Choose a place for installation that is as far as possible out
•
of the reach of domestic animals and livestock.
The mains socket must be located close to the router and be
•
easily accessible.
Lay the cables so that no one can step on or trip over them.
•
Connect cables only to the designated sockets, use only
•
approved accessories.
Do not allow liquids to infiltrate the interior of the router (risk
•
of electric shock or short circuit).
Avoid direct sunlight. Ensure sufficient ventilation.
•
Avoid operating in the direct vicinity of a radiator.
•
Before drilling, make sure that there is no domestic
•
installation at the drilling site. Damage to gas, power, signal,
or water lines may result in danger to life or property.
Ventilation slots are required for cooling and must not be
•
covered.
The unit may only be operated with the enclosed plug-in
•
power supply unit.
Safety instructions
88
Need help?
Do you have a question about the be.IP swift and is the answer not in the manual?