Telephony Menu / Ports - bintec elmeg be.IP swift User Manual

1. For the country setting, select the country in which you operate
the be.IP swift.
2. The International Prefix / Country Code entry defaults to 00 / 49
for Germany.
3. Enter the National Prefix / City Code parameter for the location
where your system is installed. By default, the prefix is preset
with 0. You must enter the city code for your location yourself,
e.g. 911 for Nuremberg.
4. VoIP providers that are not assigned a location require an
interface for establishing a connection. In the section
Registration behavior for VoIP providers without assigned
location, you can set one of the created interfaces as the default
for this case in the Default Interface field.
In the Default Interface VoIP Backup field, you can also specify
that a second Internet connection is used for a VoIP backup that
has been set up.
5. For ISDN Port configuration, select the port to which your
telephone system is connected. For ISDN 1 (bri-0) and ISDN 2
(bri-1) below are available for selection: Point-to-multipoint
(multi-device connection) Point-to-point (system connection).
Click on OK.

8.2 Telephony menu / ports

The current tab guides you through the settings required to configure
a port.
In the overview, all ports that have already been configured are
displayed in a list.
Telephony Menu in Operation as a Media Gateway 46