Pepperl+Fuchs R2-SP-IC Series Manual page 23

Segment Protector
Installation and Commissioning
Terminating a Spring Trunk Terminal
1. Plug in the M-FT terminator using the 2 entries shown in the picture.
2. Push down the M-FT.
3. Ensure that the M-FT is fully plugged in as shown.
In order to remove the M-FT, proceed as follows: Use a tool, e.g., a screw driver, to press down
the 2 springs of the terminal shown in the picture.
Press down both springs simultaneously and pull out the M-FT.
Note that the M-FT is included in the delivery.
2
1
3
23