Configuring The Module; Configuration Overview - 3Com CoreBuilder 5000 User Manual

C
4
This chapter describes how to configure CoreBuilder
Media Modules.
This chapter contains the following sections:
For additional information on network management commands
described in this section, refer to the CoreBuilder 5000 Distributed
Management Module Commands Guide.
Configuration CoreBuilder 5000 network management modules provide network
Overview management for the CoreBuilder 5000 Integrated System Hub and its
modules. If you are using a Distributed Management Module (DMM),
the DIP switch settings on the media module are ignored (unless you
set up the DMM to configure the module from DIP switches). For this
reason, use network management commands, rather than the DIP
switches, to configure the module.
ONFIGURING THE
Configuring the Modules
Configuring Trunks
Saving the Configuration
Showing Module Configurations
Monitoring the Front Panel
LED and Network Verification
M
ODULE
™
5000 Token Ring