Table of Contents
Advertisement
ABOUT THE MINIMC
The MiniMc provides a single conversion between 10/100 Base-T
twisted pair and 100 Base-SX/FX fiber. This device Auto Negotiates
speed and duplex on the copper port and the fiber 100Mbps, FDX.
There is a fixed fiber and an SFP version available; both support jumbo
frames up to 1916 MTU.
The MiniMc, TX/FX is a fixed fiber transceiver model, includes one
10/100Mbps RJ-45 connector and one 100Mbps SC fiber connector
which can support Single Mode fiber or Multi Mode fiber in Dual Strand
or Single Strand fiber.
The MiniMc, SFP* is an SFP port-based model, includes one 10/100
Mbps RJ-45 connector and one SFP port, which was designed to support
MSA-compliant 100Mbps SFPs. One of the models offers a DIP Switch to
set LFPT (Link Fault Pass-Through), a diagnostic feature for
troubleshooting a fault condition on a segment. Each model will detect
the SFP and run at the speed for which the SFP was designed. SFPs can
be purchased from B&B Electronics to accommodate Single Mode or
Multi Mode fiber in Dual Strand, and Single Strand fiber for Single
Mode.
NOTE: CWDM fiber options are available for all models
.
5
Advertisement
Table of Contents
Need help?
Do you have a question about the B+B SmartWorx MiniMc TP-TX/FX and is the answer not in the manual?
Questions and answers