BALL HEAD JOINT (CODE EPTWCBHEAD - OPTIONAL)
1
3
2
Remove the bracket, (see point 1, paragraph 13). Mount the center mounting bracket as follows
1. Loosen the two screws and remove the internal reinforced plate for bracket (1).
2. Screw the ball head joint to the bracket using the marked screw. The anti-rotation pins must coin-
cide with the provided holes (2)
3. Mount the marked internal reinforced plate for bracket by tightening the two screws (3).
NOTE: To remove the accessory, reverse the procedure.
Fig. 13
PROLIGHTS - Ecl Panel TWCM2X1
48