Installation With Adapter Plate - Besam PowerSwing Installation Manual

Installation with Adapter Plate

Preparation of Adapter Plate
Locating and Creating Slot in the Cover for the Drive Shaft
PowerSwing US23-0922-02
© Copyright 2006 Besam Entrance Solutions. May not be reprinted or reproduced without permission.
Note: Consider all power wire entry locations and secondary signaling wires
before preparing adapter plate.
1. Cut the adapter plate to correct length, L.
2. Establish the "hinge center line", C L 1.
3. Mark and drill the six holes ø 8 mm (5/16") for the fi xing of the adapter plate
to the jambs and header. Countersink two holes as shown in the illustration
so that the screw heads do not interfere with the operator.
4. Mark, drill and thread 6 holes for the fi xing of the operator and 4 holes for
fi xing of the cover mounting clips with end plates.
1. Use a 1" hole saw to cut the round hole for the output spindle.
2. Use a sabre saw to make two straight cuts.
10-21-2002
Mechanical Installation
13