Directed XpressStart Basic Installation Instructions page 10

Troubleshooting Diagnostic Flashes
While running on remote start, any of the following will cause vehicle shut down
opening the hood (7 flashes)
depressing the brake pedal (6 flashes)
increasing the RPM over normal idle (8 flashes)
three failed starts/low RPM (9 flashes)
communications error (10 flashes)
The vehicle will be limited to (5) remote starts between normal keyed operation.
If the lights flash (5) times the starter is out of sync with the vehicle. This is a rare occurrence. Should it happen, you must start the
vehicle with the key or the KeylessGo button for at least one minute to synchronize.
10 © 2012 Directed. All rights reserved.