Table of Contents
Advertisement
5.
Lift the side of the system board upward (3), and then pull the system board away from the connectors
on the side of the computer to remove it (4).
Reverse this procedure to install the system board.
Power connector cable
To remove the power connector cable, use this procedure and illustration.
Table 6-10
Power connector cable description and part number
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the power connector cable:
1.
Move the antenna cables that route over the screws.
2.
Remove the two Phillips M2.5 × 4.0 screws (1) that secure the right display hinge to the computer, and
then rotate the hinge off the power connector (2).
3.
Disconnect the cable from the system board (3).
Preparation for disassembly on page
Bottom cover on page
37).
37).
Battery on page
44).
Power connector cable
Spare part number
M21154-001
55
Hide quick links:
Advertisement
Table of Contents
