Solid-State Drive - HP EliteBook 630 Maintenance And Service Manual

2. Carefully disconnect the two antenna cables from the module (1).
3. Remove the Phillips M2.0 × 2.5 screw (2), and then remove the WLAN module (3).
NOTE:
WLAN antenna cable connects to the WLAN module #1 Aux terminal.
4. If the WLAN antenna is not connected to the terminal on the WLAN module, install a protective sleeve on
the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WLAN module.

Solid-state drive

To remove the M.2 solid-state drive, use this procedure and illustration.
The #1 white WLAN antenna cable connects to the WLAN module #1 Main terminal. The #2 black
Solid-state drive 41