Setting Up The Pro3200 Hardware; Setting The Jumpers; Table 1 Pro3200 Jumper Settings - Honeywell PRO3200 Installation And Configuration Manual

PRO3200 Installation

Setting Up the PRO3200 Hardware

3 Setting Up the PRO3200 Hardware
The PRO3200 processor is configured with 12 jumpers and a set of 4 DIP switches.
These jumpers/switches set up the port interface, end of line termination, and
operating mode configuration. Refer to the tables below to set the jumpers as required.

3.1 Setting the Jumpers

Table 1 PRO3200 Jumper Settings

Jumpers
J1
J2
J3
J4
J5
J6
J7
J8, J9, J10
J11
J12
10 www.honeywell.com
Set At Description
N/A Factory Use only.
N/A Factory Use Only
OFF Port 2 RS-485 EOL Terminator is OFF
ON Port 2 RS-485 EOL Terminator is ON
OFF Port 3 RS-485 EOL Terminator is OFF
ON Port 3 RS-485 EOL Terminator is ON
OFF Port 1 RS-485 EOL Terminator is OFF
ON Port 1 RS-485 EOL Terminator is ON
N/A Factory Use Only
N/A Factory Use only.
232 Port 1 is RS-232
485 Port 1 is RS-485
N/A Factory Use Only
N/A Factory Use Only