Honeywell PRO3200 Installation And Configuration Manual page 27

1. From PRO3200 Communication Address drop-down list, select one of the eight (0 to 7)
2. For the Primary Host Port, make the following selections:
3. For the Alternate Host Port, make the following selections:
4. Click OK.
PRO3200 (PRO32IC) Installation and Configuration Guide, Document 800-15494
available communication addresses for the PRO3200 board.
In the previous panels, this selection was made manually by setting the DIP switches.
Note:
a. Data Security. Select one of the following:
– None
– Password/AES from the drop-down list. If you select Password/AES,
communications between the WIN-PAK Host and the PRO3200 panel are
encrypted. Note that encryption must be enabled in WIN-PAK for the appropriate
WIN-PAKchannel. See Chapter 7, "Hardware Configuration," in the WIN-PAK
Guide for channel encryption instructions.
b. Port Number. Enter the port number through which the host computer can communicate
with the PRO3200 board.
c. Select either Allow All or the Authorized IP Address Required option button.
– Allow All, as the label suggests, allows all IP addresses to communicate with the
PRO3200. Select this option for web page browser access.
– If you select the Authorized IP Address Required option, also enter in the
Authorized IP Addresses fields all the IP addresses that would be allowed to
communicate with the PRO3200. Use this option only for Host communication.
a. Connection Type. Select one of the following values from the drop-down list: IP
Server, Serial-RS232, Serial-RS485, Serial-Modem. Note that the IPClient option is
listed, but it is not supported by the panel and should not be selected.
b. Data Security. Select one of the following values from the drop-down list: None,
Password/no AES, Password/AES.
c. Select a Baud Rate from the drop-down list.
d. Select a Flow Control from the drop-down list.
PRO3200 Installation
System Configuration via Web Interface
21