Care And Maintenance - Cocraft HMT300 Original Instructions Manual

Turning the multi-tool on
1. Make sure that
the power switch
(2) is set to 0 (off)
before plugging
the multi-tool's
mains lead into
a wall socket.
Select the required speed
The speed can be adjusted during use using the speed selector (3). The speed selected should
be appropriate for the type of work being carried out and the type of material being worked on.
Experiment until you find the best speed setting. The multi-tool is equipped with constant
electronics which allows it to keep to the set speed setting even under load.
Cutting and sawing
Caution should be observed when using the saw blades. Check the working area so that you
are prepared for any nails, screws or anything else which could cause you to lose control over
the multi-tool. If you are cutting wall tiles, bear in mind that the saw blade will be subjected to
hard wear during prolonged use.
Sanding
• Always use undamaged sandpaper and change it often. This will not only give you better
results but also prolong the life of your multi-tool.
• Do not use excessive force when sanding, apply a constant, light pressure. Applying too
much pressure will not speed up the sanding process; it will merely wear out the sandpaper
and the multi-tool more quickly.
• When sanding wood, do not use sanding sheets which have previously been used for metal.

Care and maintenance

• If the mains lead is damaged it must only be replaced by a qualified electrician.
• Keep the motor ventilation openings (5) free from contaminants.
• Clean the multi-tool using a damp cloth. Use only mild cleaning agents, never solvents or
corrosive chemicals.
• If the mains lead is damaged it should only be replaced by a qualified electrician.
• If the multi-tool is not to be used for an extended period, it should be unplugged and stored
in a dry and dust-free location out of reach of children.
2. Start the multi-
tool by sliding
the power
switch to
the 1 position
(on).